一、風機正常運行2-3小時后，停機檢查，調整皮帶。

Stop and Adjust V-belts after blower normally operation 2-3 hours later.

調整皮帶的步驟 V-belts adjust steps：

1.首先將電機底座下固定橫擔的4個螺栓松開，但不要卸掉。

Loose but don't unload the 4 bolts which are located under motor base frame.

2.將電機后面的1個頂絲松開用電機前面的2個頂絲將電機水平往后移，根據皮帶松緊的程度不同，可將電機后頂5—25mm不等。

Loose 1 top bolt then move the motor backward with the front 2 top bolts. The motor could move 5-25mm according to belts tightness difference.

3.然后用直尺校正風機輪與電機輪是否平行，誤差在1mm之內正常，最后將頂絲備緊，橫擔螺絲緊固。

Adjust with straight rule, make sure blower pulley and motor pulley parallel (allowable deviation is within 1mm). At last, tighten top bolts.

4.切記一定要保持每根皮帶松緊度一樣。

Make sure each belt's tightness same with each other.

二、如皮帶松動，會造成以下問題V-belts loose will cause below problems:

1.皮帶與皮帶輪打滑，磨損皮帶，造成皮帶斷裂。