空氣霧化噴嘴壓力傳送式噴霧裝置（外混式）

霧化噴嘴有點和特性：

通過外部混合裝置，無需改變液體流量，只需改變空氣壓力，即可對霧化進行控制。

對于扇形噴霧，尺寸A，B,和C是距離噴嘴相應距離處的噴霧角度；

Through the external mixing device, without changing the liquid flow, only need to change the air pressure, can to control the atomization.

For the fan-shaped spray, size A, B, and C corresponding distance is the distance the nozzle spray Angle;

The spray from the nozzle to the maximum dispersion point projection a total distance of D;

When using pressure conveying liquid system, liquid by pressure was taken to the nozzle;

Liquid and compressed air or other gas is mixed in the outside, to produce fully atomized spray;

上海斐卓噴霧系統公司壓力霧化噴嘴FN設計特點

壓力霧化噴嘴FN采用單元組合式連接方式，加裝過濾網，便于清洗。

為了更好的霧化，建議壓力霧化噴嘴FN的入口壓力在5 巴以上。

一般應用

●紡織廠加濕

●空調房加濕

●煙囪內煙氣冷卻

●噴霧干燥

●垃圾站除臭

●噴灑化工原料

●消毒滅菌

壓力霧化噴嘴FN系列產品更多的參數請聯系斐卓Feizhuo噴霧系統公司！或者登陸斐卓網站進行查看咨詢！

空氣霧化噴嘴通過外部混合裝置改變氣體壓力而不改變液體流率來控制霧化，對于扇形噴霧，尺寸”A“流型寬度,如圖所示。噴嘴從噴嘴投射到很大彌散點的總距離為“D”。

霧化噴嘴可以隨時的調整氣壓和水壓，比例可隨時調整，1：15.

噴霧角度為扇形和實心。角度60°。

接口螺紋大小為3/4.

Air atomizing nozzle changing gas pressure by external mixing device without changing the liquid flow rate to control the atomization, the fan-shaped spray, dimension 'A' type flow width, as shown.Nozzle of projects from the nozzle to the maximum dispersion point total distance for the 'D'.

Atomizing nozzle can adjust the air pressure and water pressure, ratio can be adjusted at any time, 1:15.

The spray Angle for the fan and solid.Angle 60 °.

Interface thread size for three quarters.